Name: Temecula Valley European
Address: 26765 Madison Ave Suite 107, Murrieta, CA, 92562
Telephone: (951) 406-6508

2014 BMW 428i
Mileage
118,018
Service Date
2/2/2026
Services Performed
Found a spun bearing and metal shavings in the oil
ENGINE ASSEMBLY – Removal & Installation – Coupe,Automatic Trans – [Includes: R&I only those components necessary for the removal of the complete Engine Assembly. DOES NOT include transfer components or tune Engine.]
Nathan L. gave our service a 5 star review on 2/9/2026
2014 BMW 428i
Mileage
117,090
Service Date
12/16/2025
Services Performed
Advise the customer that they need engine mounts.
Found
Rotate tires
Nathan L. gave our service a 5 star review on 12/16/2025
2014 BMW 428i
Mileage
109,388
Service Date
8/1/2025
Services Performed
TRANSMISSION OIL PAN GASKET &/OR FILTER – Remove & Replace
Confirmed the cold-start stall comes from a torn PCV diaphragm in the valve cover, which is also leaking oil, letting un-metered air into cylinders 1-2. Crankcase vacuum read 0 in-Hg (spec –11) and fuel trims spiked +19 % when the breather was blocked, proving the leak. Valve-cover/PCV assembly is faulty and must be replaced to stop the oil leak, restore proper mixture, and eliminate the stall.
VALVE COVER GASKET – Remove & Replace – Coupe
Nathan L. gave our service a 5 star review on 8/1/2025
2004 BMW 325i
Mileage
177,197
Service Date
4/3/2025
Services Performed
Check the condition of the following components: brakes, drive belts, battery cables, starter operation, intake system, vacuum hoses, air filter, fuel system, ignition system, cooling system, hoses and fan Check level and condition of the following fluids: coolant, engine oil, transmission, power steering, brake and waster Drain engine oil. Remove engine oil filter. Install new engine oil drain plug gasket if applicable and torque engine oil drain plug to factory specification. Install new engine oil filter and torque to factory specification.
Adjust tire pressure to factory specification
Reset service reminder if needed.
Remove and replace windshield wipers – no charge
Frank A. gave our service a 5 star review on 4/18/2025
2022 BMW X3
Mileage
49,628
Service Date
2/17/2025
Services Performed
Check the condition of the following components: brakes, drive belts, battery cables, starter operation, intake system, vacuum hoses, air filter, fuel system, ignition system, cooling system, hoses and fan Check level and condition of the following fluids: coolant, engine oil, transmission, power steering, brake and waster Drain engine oil. Remove engine oil filter. Install new engine oil drain plug gasket if applicable and torque engine oil drain plug to factory specification. Install new engine oil filter and torque to factory specification.
Adjust tire pressure to factory specification
Reset service reminder if needed.
Mike K. gave our service a 5 star review on 2/17/2025
2015 BMW X5
Mileage
102,419
Service Date
1/28/2025
Services Performed
All braking components were inspected and found to have sufficient life remaining. We can address the squeaking by removing the brake pads and sanding the top layer of the braking material, which should help reduce the noise.
Both batteries have been tested and found to be faulty. Upon further investigation, it was determined that the batteries were not registered during their last replacement. When batteries are not registered, the vehicle's alternator and charging system do not receive updated parameters, leading to overcharging and premature failure. This overcharging is likely the cause of the batteries failing after just two years. We recommend replacing the batteries and ensuring they are properly registered with the vehicle’s system to prevent this issue in the future.
All diagnostic codes are related to the vehicle experiencing under voltage. Upon further inspection, the issue appears to be with the batteries, as noted in the battery line. We recommend addressing the battery issue to resolve the under voltage problem and prevent any related electrical concerns.
Remove and replace brake pads, sand glaze off braking material.
BATTERY – Remove & Replace – Main and Auxiliary – [Includes: Test.]
This dealer is required by law to charge a nonrefundable $2.00 California battery fee and a refundable deposit for each lead-acid battery purchased. A credit of the same amount as the refundable deposit will be issued if a used lead-acid battery is return
Cody W. gave our service a 5 star review on 1/31/2025
2006 BMW X3
Mileage
198,769
Service Date
10/11/2024
Services Performed
After scanning the vehicle, no fault codes were found. Upon examining live data from the oxygen sensors, it was observed that their response was slow. It is advised to start by replacing the front two oxygen sensors. Following their replacement, the vehicle's monitors still failed to set. Next, the back two oxygen sensors were replaced. During a road test, the vehicle began to misfire and lost power. This indicated that with accurate air-fuel ratio data, a misfire was now being detected. All six spark plugs were then removed and replaced with new ones, and two used ignition coils were installed. The oxygen sensor adaptation was cleared, and the vehicle underwent another road test. All smog monitors are currently set.
OXYGEN SENSOR – Remove & Replace – Front,Both
OXYGEN SENSOR – Remove & Replace – Rear,Both
Safety Inspection
SPARK PLUGS – Remove & Replace
Peter M. gave our service a 5 star review on 10/11/2024
2008 BMW 128i
Mileage
85,032
Service Date
7/16/2024
Services Performed
Check the condition of the following components: brakes, drive belts, battery cables, starter operation, intake system, vacuum hoses, air filter, fuel system, ignition system, cooling system, hoses and fan Check level and condition of the following fluids: coolant, engine oil, transmission, power steering, brake and waster Drain engine oil. Remove engine oil filter. Install new engine oil drain plug gasket if applicable and torque engine oil drain plug to factory specification. Install new engine oil filter and torque to factory specification.
Adjust tire pressure to factory specification
Reset service reminder if needed.
TRANSMISSION OIL PAN GASKET &/OR FILTER – Remove & Replace
Mel R. gave our service a 5 star review on 7/17/2024
2004 BMW 325i
Mileage
174,665
Service Date
6/6/2024
Services Performed
Check the condition of the following components: brakes, drive belts, battery cables, starter operation, intake system, vacuum hoses, air filter, fuel system, ignition system, cooling system, hoses and fan Check level and condition of the following fluids: coolant, engine oil, transmission, power steering, brake and waster Drain engine oil. Remove engine oil filter. Install new engine oil drain plug gasket if applicable and torque engine oil drain plug to factory specification. Install new engine oil filter and torque to factory specification.
Adjust tire pressure to factory specification
Reset service reminder if needed.
Frank A. gave our service a 5 star review on 6/10/2024
2011 BMW X3
Mileage
160,198
Service Date
5/16/2024
Services Performed
Found. 130308 VANOS, exhaust: control fault, position not reached Intermittent 130D01 Crankshaft – exhaust camshaft, reference: Angle difference outside of limit value Intermittent 163201 Exhaust-camshaft sensor, electric: no signal Intermittent Recommending removal and replacement of engine assembly
Socorro G. gave our service a 5 star review on 5/16/2024

BMW