Found front control arms bushings to be worn out to the point where the metal control arm is rubbing on the aluminum subframe. The vehicle is very unsafe to drive. Also found the drivers front shock to be leaking hydraulic oil. Recommending removal and replacement of drivers front shock, and both front rearward control arms.
Remove and replace both lower control arms.
Replaced recommended components and test drove vehicle. On test drive found that vehicle still has a minor noise in reverse, when the steering wheel is turning all the way to the right. Suspect convertible top frame needs to be tightened. All components operating as intended at this time.
Gary W. gave our service a 5 star review on 4/4/2024
Check the condition of the following components: brakes, drive belts, battery cables, starter operation, intake system, vacuum hoses, air filter, fuel system, ignition system, cooling system, hoses and fan Check level and condition of the following fluids: coolant, engine oil, transmission, power steering, brake and waster Drain engine oil. Remove engine oil filter. Install new engine oil drain plug gasket if applicable and torque engine oil drain plug to factory specification. Install new engine oil filter and torque to factory specification.
Adjust tire pressure to factory specification
Reset service reminder if needed.
P0299 The boost pressure of turbocharger 1 is too low
Shahna T. gave our service a 5 star review on 10/20/2023
Found evidence of rodent damage in wiring underneath vehicle. Repaired chewed wiring, road tested vehicle. Vehicle is operating as intended at this time.
Found one bulb burnt out on vehicle. Replaced and tested. Vehicle is operating as intended at this time.
Customer requests for technician to set the time in the vehicle
Fernando M. gave our service a 5 star review on 8/23/2023
Check the condition of the following components: brakes, drive belts, battery cables, starter operation, intake system, vacuum hoses, air filter, fuel system, ignition system, cooling system, hoses and fan Check level and condition of the following fluids: coolant, engine oil, transmission, power steering, brake and waster Drain engine oil. Remove engine oil filter. Install new engine oil drain plug gasket if applicable and torque engine oil drain plug to factory specification. Install new engine oil filter and torque to factory specification.
Found 2 faults C155664 The compressed air sensor for system pressure has a malfunction. There is an implausible signal. C157300 The correction time when emptying too long.
Shahna T. gave our service a 5 star review on 7/11/2023
Check the condition of the following components: brakes, drive belts, battery cables, starter operation, intake system, vacuum hoses, air filter, fuel system, ignition system, cooling system, hoses and fan Check level and condition of the following fluids: coolant, engine oil, transmission, power steering, brake and waster Drain engine oil. Remove engine oil filter. Install new engine oil drain plug gasket if applicable and torque engine oil drain plug to factory specification. Install new engine oil filter and torque to factory specification.
Rotate tires
Adjust tire pressure to factory specification
Reset service reminder if needed.
Simon S. gave our service a 5 star review on 6/26/2023